Installing the Power Switch
1.
Push the power switch into its slot and press it in, until it snaps into place.
2.
Route the power-switch cable through the metal clip.
3.
Connect the power-switch cable to the connector on the system board.
4.
Close the front-bezel door.
5.
Install the:
•
bezel
•
cover
6.
Follow the procedures in
Removing the Coin-cell Battery
1.
Follow the procedures in
2.
Remove the:
•
cover
•
bezel
3.
Open the
front-bezel
4.
Perform the following steps to remove the coin-cell battery from the system board:
a. Press the release latch until the coin-cell battery pops-out.
b. Remove the coin-cell battery from the system board.
After Working Inside Your
Before Working Inside Your
door.
Computer.
Computer.
17