4. Disconnect the signal cable and the power cable from the rear of the optical drive, and then remove the
screw that secures the optical drive.
Figure 9. Removing the optical drive screw
5. Slide the optical drive out of the front of the computer.
Figure 10. Removing the optical drive
6. Hold one end of the optical drive bezel and remove it from the optical drive as shown.
Figure 11. Removing the optical drive bezel
7. Take the new optical drive out of the static-protective package by its sides.
8. Hold one end of the optical drive bezel and install it on the optical drive.
.
Chapter 7
Installing or replacing hardware
49