Table of Contents
Advertisement
PROBLEM
Steam and condensation
settle on the food and in the
cavity of the oven.
The oven does not heat up.
The oven does not heat up.
The turnspit does not rotate. The turnspit is not correctly
It takes too long to cook the
dishes or they cook too
quickly.
The display shows an error
code that is not in this ta-
ble.
Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
WE RECOMMEND THAT YOU WRITE THE DATA HERE:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
POSSIBLE CAUSE
You left the dish in the oven
for too long.
The clock is not set.
The necessary settings are
not set.
installed into the turnspit
hole.
The temperature is too low
or too high.
There is an electrical fault.
The necessary data for the service centre
is on the rating plate. The rating plate is on
the front frame of the appliance cavity. Do
not remove the rating plate from the
appliance cavity.
.........................................
.........................................
.........................................
TROUBLESHOOTING
REMEDY
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing process ends.
Set the clock.
Make sure that the settings
are correct.
Refer to "Using the turn-
spit".
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Deactivate the oven with the
house fuse or the safety
switch in the fuse box and
activate it again.
If the display shows the er-
ror code again, contact the
Customer Care Department.
29
Advertisement
Table of Contents
