Table of Contents
Advertisement
2
1
Figure 11
1. Lift lever
2. Button
3. Dial-A-Height
Adjusting the Dial-A-Height
The Dial-A-Height control (Fig. 11) is used to limit the
downward travel of the attachment. The Dial-A-Height
knob is rotated to change the location of this stop, up or
down.
1. Raise the attachment lift lever: Refer to Raising
Attachments. In the raised position the Dial-A-Height
knob (Fig. 11) can be rotated to change the stop
location. Turn clockwise to raise and counterclockwise
to lower the height of the attachment.
2. The Dial-A-Height indicator (Fig. 11) will show the
change, high to low, in attachment lift height as
adjustment is made.
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. Raise the seat and loosen the adjustment knobs
(Fig. 12).
2. Slide the seat to the desired position and tighten the
knobs.
3
5
4
6
1205
4. Indicator
5. High
6. Mounting position
20
1
Figure 12
1. Adjustment knob
Using the Headlights
The headlights are turned on with a separate position,
lights, of the ignition switch (Fig. 13). The lights are on
while the ignition switch is in the lights position even with
the engine off. Remove the key when the machine is left
unattended so lights can not be turned on discharging the
battery.
Figure 13
1. Lights
Positioning the Tilt Steering
Wheel
The steering wheel has four tilt locations. Position the
steering wheel where you have the best control of the
machine and are most comfortable.
1. Lift the tilt lever to release the lock (Fig. 14).
2. Move the steering wheel to a comfortable position;
then release the lever to lock.
1
1208
Advertisement
Table of Contents
