Toro 51563 Operator's Manual page 4

Setup
1
Assembling the Blower
Parts needed for this procedure:
1 Blower tube
1 Inlet cover
Procedure
Install the blower tube and then the inlet cover onto the blower
housing.
Important: You must install the blower tube before
installing the inlet cover, because the inlet cover hooks
onto the blower tube. The blower should not run without
the bottom inlet cover locked in place.
Note: If the blower runs without the inlet cover in place, do
not use the blower. Return it to a Toro service dealer.
2
Converting from Blower to
Vacuum
Parts needed for this procedure:
1 Vacuum tube
1 Vacuum bag
Procedure
WARNING
The impeller rotates for a few seconds after you turn
off the blower and can cut or injure fingers.
Do not remove the bottom inlet cover when the motor is
running or when the unit is plugged into a power outlet.
1. Remove the inlet cover and the blower tube from the blower
housing.
2. Install the vacuum tube onto the blower housing and connect
the lower vacuum tube to the upper tube, securing it with
the supplied fastener.
Important: The blower should not run without the
bottom inlet cover locked in place.
Note: Note: If the blower runs without the inlet cover
in place, do not use the blower. Return it to a Toro
service dealer.
Note: You may need to push the connector firmly to
ensure that it seats all the way into the vacuum tube.
4