What To Do In The Event Of A Fault - Siemens LD97AA670 Instruction Manual

Hide thumbs Also See for LD97AA670:
Table of Contents

Advertisement

What to do in the event of a fault

Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
LED lights
Defective LED lights must only be replaced by the
manufacturer, their customer service department or a licensed
technician (electrician).
What to do if water gets in
If water gets in to the appliance during cooking or cleaning,
proceed as follows:
Switch off the appliance.
1.
Open the floor cupboard and mop up leaking water.
2.
Leave the appliance switched off for 24 hours.
3.
After this time, the appliance can be used again without
restrictions.
10
Malfunction table
Problem
Possible cause
The safety switch-
is shown on
‚‚
off function is deac-
the display.
tivated. With the
safety switch-off
function deacti-
vated, the appli-
ance extends and
retracts and will be
ready to use again
after around
30 seconds.
:
Risk of injury!
Risk of crushing
when the appliance
is extending and
retracting. Stop
using the appli-
ance. Keep children
away from the
appliance.
The appliance
The plug is not
does not work
plugged in.
Power cut
Faulty fuse
Appliance does
Filter cover not
not switch on.
closed.
The appliance
The circuit breaker
does not extend
in the electrical box
or retract.
is defective.
The 7 segment
The operating mod-
display is not
ule is defective.
working.
The lighting
The LED lights are
does not work.
defective.
The grease or acti-
If
or
ª
'
vated charcoal filter
appears on the
is saturated.
display
--------
Solution
Note: Disconnect the
appliance from the
power supply. The appli-
ance needs to be
repaired. Call the after-
sales service.
Connect the appliance
to the electricity supply
Check whether other
kitchen appliances are
working
Check in the fuse box to
make sure that the fuse
for the appliance is OK
Close the filter cover
fully.
Call the after-sales
service.
Call the after-sales
service.
Call the after-sales
service.
Clean the filter – see
section "Cleaning and
maintenance".

Advertisement

Table of Contents
loading

Table of Contents