Toro 30605 Operator's Manual page 24

Figure 15
6. Push the caster spindle through the front caster arm
and install the shims (as they were originally installed)
and the remaining spacers onto the spindle shaft.
7. Install the tensioning cap to secure the assembly.
8. Remove the hairpin cotter and clevis pin securing the
height-of-cut chains to the rear of the mower deck
(Figure 16).
Figure 16
1. Height-of-cut chain
9. Mount the height-of-cut chains to the desired
height-of-cut hole with the clevis pin and hairpin cotter
(Figure 17).
Figure 17
Note: When using 25 mm (1 inch), 38 mm (1-1/2 inch),
or 51 mm (2 inch) heights of cut, move the skids and gauge
wheels to the highest position.
2. Clevis pin and hairpin
cotter
Wing Mower Decks
To adjust the height of cut on the wing mower decks, add
or remove an equal number of spacers from the caster
forks, position the caster-wheel axles in the high or low
height-of-cut holes in the caster forks, and secure the pivot
arms to the selected height-of-cut bracket holes.
1. Position the caster-wheel axles in the same holes in all
of the caster forks
2. Remove the tensioning cap from the spindle shaft and
slide the spindle out of the caster arm
1. Tensioning cap
2. Spacers
3. Shims
3. Install the 2 shims onto the spindle shaft as they were
originally installed.
Note: These shims are required to achieve a level
across the entire width of the mower decks. Slide the
appropriate number of 13 mm (1/2 inch) spacers onto
the spindle shaft to get the desired height-of-cut; then
slide the washer onto the shaft.
Refer to the following chart to determine the
combinations of spacers for the setting
4. Push the caster spindle through the front caster arm
and install the shims (as they were originally installed)
and the remaining spacers onto the spindle shaft.
24
(Figure 18 and Figure 20).
(Figure
Figure 18
4. Top axle-mounting hole
5. Caster wheel
(Figure
Figure 19
18).
19).