Selecting The Input Signal - Panasonic TH-42PH20ER Operating Instructions Manual

Selecting the input signal

Press to select the input signal to be played back from the equipment which has
been connected to the Plasma Display.
Input signals will change as follows:
PC: PC input terminal in PC IN.
VIDEO: Video input terminal in AV IN (VIDEO).
COMPONENT*: Component or RGB input terminal in COMPONENT/RGB IN.
HDMI: HDMI input terminal in AV IN (HDMI).
DVI: DVI input terminal in DVI-D IN.
* "COMPONENT" may be displayed as "RGB" depending on the setting of
"Component/RGB-in select".
When an optional Terminal Board is installed:
PC
SLOT INPUT: Input terminal in Terminal Board
Note:
When a Terminal Board incompatible with the Plasma Display is installed,
"Non-Compatible Function Board" is displayed.
When a Terminal Board with dual input terminals is installed:
PC
SLOT INPUT A, SLOT INPUT B: Dual input terminal in Terminal Board
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Outputs the sound as set in "Audio input select" in the Options menu.
• Select to match the signals from the source connected to the component/RGB input
terminals.
• Image retention (image lag) may occur on the plasma display panel when a still picture
is kept on the panel for an extended period. The function that darkens the screen
slightly is activated to prevent image retention, but this function is not the perfect
solution to image retention.
14
PC VIDEO COMPONENT*
SLOT INPUT VIDEO
SLOT INPUT A SLOT INPUT B
HDMI DVI
COMPONENT HDMI
VIDEO COMPONENT
DVI
HDMI DVI
+
INPUT MENU -/ VOL / ENTER/
+
INPUT MENU - / VOL / ENTER/