Siemens WT48Y890GB Installation And Operating Manual page 28

Table of Contents

Advertisement

Programmes and buttons
en
× Options
ø Spin class
Û Fine adjustment
of the dryness level
Ù Low heat
Memory 1/2
Basic Settings
3 sec.
End signal, button
signal
Automatic switch-off Automatically switching off the dryer after 15, 30 or 60 minutes, or never automati-
Language
Start/Pause Ü
--------
28
Select the button and the menu will be displayed in the display panel.
For the spin class, set the spin speed at which the laundry has been spun in the
washing machine. This permits the expected drying time to be indicated more pre-
cisely. Speeds of between 600 and 1800 rpm can be selected. Default setting:
1000 rpm
If the laundry is too damp after drying, you can finely adjust the dryness levels e.g.
Cupboard Dry. The dryness level can be increased in three stages, from +1 to +3.
If you have adjusted the dryness level, the setting for all programmes with a selecta-
ble dryness level is retained even after the dryer is switched off.
Reduced temperature for delicate fabrics, e.g. polyacrylic or elastane, may increase
the drying time.
You can save individual programme settings under Memory 1 and 2.
Select the required programme settings and press the Memory 1 or Memory 2 but-
ton for 3 seconds until the display panel shows that Memory programme 1 or 2 is
saved. Your selected programme settings are retained even after the dryer is
switched off.
Default setting: No Memory programme saved.
Press both buttons at the same time and hold them for 3 seconds. The menu will be
displayed in the display panel.
Select the button signal volume: off - quiet - normal - loud - very loud.
Default setting: loud
cally switching off. Default setting: 15 minutes
Select the desired language in the display panel.
Starts or pauses the programme.

Advertisement

Table of Contents
loading

Table of Contents