Advertisement
Common non-fault phenomenon
Phenomenon
A sound in water hose and water
Water
inlet
inlet valve.
When washing or rinsing is finished,
Washing
the pulsator will rotate slightly.
Rinsing
During the washing process,
the pulsator rotates
discontinuously.
When spinning starts, low-speed
rotation will happen for a while. (Do
not rotate at high speed immediately.)
When spinning starts, the machine
gives off sounds like "Patsa Patsa".
During spinning, the program inlets
Spinning
water and enters rinsing.
(Indicating light of spin blinks
quickly.)
The clothing has been spin dried
but not wringed dry.
Operating parts heat up.
Indoor lighting darkens in an
instant.
Rotate the tub body with your
hand, there's a sound of water
shaking.
Others
There's a stray noise on the radio
or television, and the image is
unclear.
After washing is finished, there
are white lines around the
washing / spin drying tub.
16
Not a fault
Because the pressure of tap water is relatively high.
Please adjust tap connection.
To avoid the offset of clothing to reduce vibration during
spin drying.
In the soaking and washing in soak course, the pulsator
rotates once every 8 seconds, so that the detergent can
permeate into the clothing sufficiently.
This action is done to adjust the balance and to dry clothing
sufficiently.
During spin drying, water hits the tub side, which is not
abnormal.
During the rotation in spin drying, the offset of clothing is
detected and corrected automatically.
(If the offset phenomenon can not be changed by
auto-correction, the operation will stop immediately.)
The spin drying ratio of an automatic washing machine is
a little lower than that of a twin tub washing machine.
In case the spin drying of large clothing such as towels,
blankets etc. is uneven, please spin drying it again.
It's caused by the heat radiation of electrical components.
The voltage of plug loop in your house drops in an instant
when the motor starts up. (Please use an exclusive plug loop.)
To keep balance during spinning, there's liquid in the balance
ring.
Keep away from radio and television as far as possible.
The white powdery material is the result of the combination
of ingredients in detergent and ingredients in water (Wipe
away with twisted cloth.) Please note that it will stick on
where it is left. Using liquid detergent or injecting water and
rinsing twice can prevent this phenomenon.
Key points of washing
Pay more attention to the following situations
Before washing, please remove sludge and sand on clothing first.
For very dirty parts of the clothes, you can smear some liquid detergent on
them and rub them in advance.
For clothing easy to pill, please turn it inside out first and then wash it.
Large clothing and clothing easy to float should be put into the washing
tub first.
Please put large clothing and clothing easy to float (chemical fibers etc.) at the bottom.
This is beneficial to the good rotation of clothing.
To avoid damage to tub, pulsator...
Please take out coin, hair clip, curtain
hook and other metal.
Wrap up buttons and zipper and put
them on the inner side.
Put bra etc. in washing mesh bag.
For better washing...
Please check the washing mark.
Wash clothing easy to fade separately.
For towels and other clothing easy to
produce lints, please wash them separately
or use washing mesh bag.
While using a washing mesh bag, put in as little clothing as possible. Too much clothing will decrease
the performance during rinsing and spin drying or cause the offset of clothing during spin drying.
To avoid damage to clothing,
winding of clothing...
Belts on apron and so on must be knotted;
zippers must be zipped.
Thin or easily damaged clothing must be
washed in washing mesh bag.
Metal decorations (zippers etc.) on the clothing
in washing mesh bag must be checked.
To protect the environment
...To avoid the waste of water, detergent
and electricity.
During washing, wash clothing together.
Put in proper amount of detergent
according to the fouling situation.
Reuse detergent liquid.
5
Advertisement
