Table of Contents
Advertisement
10
en | Installation
5.3
Wiring
Caution!
The unit has connection terminals on flying leads. In wet or outdoor installations, use a field
!
wiring box with NEMA Type 4X or IP66 protection level or better. After connections are made,
ensure the watertight compartment is tightly closed and cables and conduits are properly
sealed to prevent water ingress.
Notice!
Use proper surge suppression on cables that are routed outdoors, or close to large inductive
loads or electrical mains supply cables.
5.3.1
Cable tree
Use the following table to identify the wires in the cable tree:
Wire color
Red
Brown
Yellow / Green
Black / Orange
White / Orange
White / Violet
Orange / Violet
Violet
White
(Shield)
Black
BNC connector
5.3.2
Earthing
Caution!
This device must be connected to earth (ground).
!
Safety (power) ground is indicated by the
Connect the yellow/green wire of the camera to the system earth of the installation to ensure
correct safety and EMC/RFI protection.
5.3.3
Network (and PoE power)
Connect the camera to a 10/100 Base-T network:
–
–
03.2019 | V2.0 | AM18-Q0711
AWC
26
26
24
28
28
28
28
28
28
28
28
Use STP Category 5e cable with RJ45 connectors (the camera network socket is
Auto MDIX compliant).
Power is supplied to the camera via the Ethernet cable compliant with the Power-over-
Ethernet standard.
Signal
+12 VDC
-12 VDC
Earth
Alarm Out A
Alarm Out B
Ground (Alarm In)
Alarm In 1
Alarm In 2
Audio In
Ground (Audio)
Audio Out
CVBS analog
symbol.
Installation manual
FLEXIDOME IP starlight 6000 VR
Bosch Security Systems B.V.
Advertisement
Table of Contents
