Installation Space Requirements - Canon imageprograf iPF680 Service Manual

F.

Installation Space Requirements

The imagePROGRAF iPF685/680 printer's approximate installation space
requirements may differ, depending on how the printer is configured and the
optional accessories attached. Always ensure that there is enough space for
service and operation of the device.
Refer to the imagePROGRAF iPF685/680 Series Service Manual for details
on transportation and installation of the imagePROGRAF iPF685/680 printer.
IMPORTANT
•
Make sure that approximately 24" (600 mm) of space is left around the
front, 0.4" (10mm) is left at the back, and a minimum of approximately 8"
(200 mm) of space is left around the left, and right sides of the printer for
the proper servicing of the equipment.
•
The floor must be level (with no bows) and flat for the stabilization and
support of the printer.
•
The weight of the printer is primarily supported by the wheels.
•
Elevators used to transport the printer must have a minimum depth of
approximately 62" (1,575mm).
navigate turns.
•
The printer should never be tilted until a "move" operation has been
performed. Refer to the Service Manual for specific details.
The approximate space requirements for the imagePROGRAF iPF685/680
printer installation are shown below.
Table 16 – imagePROGRAF iPF685/680 Printer Installation Space Requirements
imagePROGRAF iPF685/680 Service Guide
imagePROGRAF iPF685/680 Service Guide
Additional room may be needed to
Height and Depth
August 2014
Page 13