Optical Drive - HP ProOne 490 G3 Maintenance And Service Manual

Optical drive

1. Prepare the computer for disassembly (see
2. Remove the stand assembly (see
3. Remove the rear cover (see
4. Disconnect the optical drive cable (1) from the optical drive.
5. Remove the Phillips #2 M3.0×4.0 screw (2) that secures the optical drive to the rear cover.
6. Remove the optical drive (3).
7. Remove the Phillips #1 M2.0×3.0 screw (1) that secures the optical drive bracket to the optical drive.
8. Remove the optical drive bracket (2).
Reverse this procedure to reassemble and install the optical drive.
Preparation for disassembly on page
Stand assembly on page
Rear cover on page 18).
16).
17).
Optical drive 21