D-Link DCS-1110 Quick Install Manual page 4

Hardware Overview
Reset Button
Reset will be initiated when the reset button is pressed once and Power LED
begins to flash.
Factory Reset will be initiated when the reset button is pressed continuously
for ten seconds. Release the reset button and the Power LED will begin to flash
indicating that the DCS-1110's settings are reverting back to the factory settings.
The IP address will also return to the default setting with DHCP selected.
Ethernet Cable Connector
The DCS-1110 features an RJ-45 connector for connections to
10Base-T Ethernet cabling or 100Base-TX Fast Ethernet cabling.
The port supports 802.3af Power over Ethernet (PoE) and the NWay
protocol, allowing the DCS-1110 to automatically detect or negotiate
the transmission speed of the network. The port also supports MDI/X,
which allows the use of either straight through or cross-over cables.
D-Link DCS-1110 Quick Install Guide
DC Power Connector
The DC power input connector is
labeled DC 5V with a single jack
socket to supply power to the
DCS-1110. The power supply is
optional if PoE is used.
4