Table of Contents
Advertisement
Connect Mode
• Always On Line: If you enable this, idle time is not taken into
account. The connection will always be alive.
• Manual Connect: When the connection is
broken by the idle time, you must press
Connect button on the Status page to
reconnect.
• Connect On Demand: When the connection
is broken by the idle time, any trigger can
make the connection alive.
Note: If you are on a leased line or pay-per min. connection,
please set your maximum idle time to 3 minutes. This
will cause your Internet connection to drop after
3 minutes of idle time so you won't be charged for extra
online time from your ISP.
Click FINISH to complete the setup.
Point-to-Point Tunneling Protocol (PPTP)
Point-to-Point Tunneling Protocol is a common connection
method used for xDSL connections in Europe. It can be used to
join different physical networks using the Internet as an
intermediary.
If you have been provided with the information as shown on the
screen, enter the PPTP Account name and password, Host
Name, Service IP Address, the assigned IP Address, and Subnet
Mask.
Leave the Maximum Transmission Unit (MTU) at the default
value (1460) unless you have a particular reason to change it.
Enter a Maximum Idle Time (in minutes) to define a maximum
period of time for which the Internet connection is maintained
during inactivity. If the connection is inactive for longer than the
Maximum Idle Time, it will be dropped. (Default: 3 minutes)
Connect Mode
• Always On Line: If you enable this, idle time is not taken into
account. The connection will always be alive.
• Manual Connect: When the connection is broken by the idle
time, you must press Connect button on the Status page to
reconnect.
• Connect On Demand: When the connection is broken by the
idle time, any trigger can make the connection alive.
Note: If you are on a leased line or pay-per min. connection,
please set your maximum idle time to 3 minutes. This
will cause your Internet connection to drop after
3 minutes of idle time so you won't be charged for extra
online time from your ISP.
Click FINISH to complete the setup.
BigPond
If you use the BigPond Internet Service which is available in
Australia, enter the the User Name, Password and Authentication
Service Name for BigPond authentication. Click FINISH to
complete the setup.
Advertisement
Table of Contents
