Getting Started; Select The Display Language And Cancel The Demonstration - Kenwood KDC-BT620U Instruction Manual

BASICS
Remote control (RC-406)
(supplied for
Remote sensor (Do not expose to
bright sunlight.)
: Remote control functions are not available.
How to replace the
battery
To On the remote control
Turn on the power Press and hold SRC to turn off the power.
( Pressing SRC does not turn on the power. )
Adjust the volume Press
• Press and hold
the volume to 15.
Press ATT during playback to attenuate the
sound.
• Press again to cancel.
Select a source Press SRC repeatedly.
4
ENGLISH
/
Pull out the insulation
sheet when using for the
first time.
or .
to continuously increase

GETTING STARTED

)
1

Select the display language and cancel the demonstration

When you turn on the power for the first time (or [FACTORY RESET] is
set to [YES], 6), the display shows: "SEL LANGUAGE" "PRESS"
"VOLUME KNOB"
1
Turn the volume knob to select the display language, then press
the knob.
Selectable display language:
/
: [EN] (English), [RU] (Russian), [TU] (Turkish), [SP] (Spanish)
[ENG]/[EN] is selected for the initial setup.
Then, the display shows: "CANCEL DEMO" "PRESS" "VOLUME
KNOB".
2 Press the volume knob.
[YES] is selected for the initial setup.
3 Press the volume knob again.
"DEMO OFF" appears.
Then, the display shows the selected crossover type: "2-WAY X ' OVER" or
"3-WAY X ' OVER"
• To change the crossover type, see "Change the crossover type". ( 6)
: [ENG] (English), [TUR] (Turkish)