Electrolux EWS1276CAU User Manual page 17

2. Wait about 2 minutes until the door
lock indicator
goes off.
3. Open the door.
4. Close the door.
5. Press again. The indicator
appears again on the display.
The delay start continues to operate.
10.12 Opening the door when
the programme operates
While the programme operates, the
appliance door is locked and the display
shows the indicator
CAUTION!
If the temperature and level
of the water in the drum are
too high, you cannot open
the door.
1. Press the button
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the appliance door.
3. Close the appliance door.
4. Set the programme again.
10.13 At the end of the
programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• In the display
• The indicator of the
• The door lock indicator
a few minutes, then goes off.
• You can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty.
• Close the water tap.
• Press the button
to deactivate the appliance.
• Keep the door ajar, to prevent the
mildew and odours.
The washing programme is
completed, but there is water in the
drum:
stops flashing and
.
for some
comes on.
goes off.
flashes for
for some seconds
• The drum turns regularly to prevent
the creases in the laundry.
• The door lock indicator
door stays locked.
• You must drain the water to open the
door.
To drain the water:
1. Press . The appliance drains the
water and spins.
2. To make the appliance drain only, set
. If necessary, decrease the
spin speed.
3. When the programme is completed,
the door lock indicator
a few minutes. When it goes off, you
can open the door.
4. Press the button
seconds to deactivate the appliance.
The appliance drains and
spins automatically after
approximately 18 hours
(except for Wool
programme).
10.14 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press
Press the button
appliance again.
• After 5 minutes from the end of the
washing programme
Press the button
appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
If you set a programme or an
option that ends with water
in the drum, the AUTO
Stand-by function doesn't
deactivate the appliance to
remind you to drain the
water.
ENGLISH 17
is on. The
flashes for
for some
.
to activate the
to activate the