Table of Contents
Advertisement
Setting Up the Expansion Enclosure
Consider the following best practices when setting up an SC460 expansion enclosure.
•
Before connecting any cables between the expansion enclosure and storage system, physically label each port and connector.
•
Always follow proper power-up and power-down procedures when cycling power across the network. Verify that critical network
components are on separate power circuits.
Other Information You May Need
To install the expansion enclosure, you may need the following additional information:
•
Dell SC460 Expansion Enclosure Owner's Manual
Provides information about an SC460 expansion enclosure, such as hardware features, replacing hardware components, and
technical specifications.
•
Dell Storage Manager Administrator's Guide
Provides instructions for using the Data Collector Manager and the Dell Storage Manager Client.
Installation and Configuration
Before you begin the installation, make sure that the site where you plan to install the expansion enclosure has standard power from
an independent source or a rack power distribution unit (PDU) with a UPS.
Safety Precautions
Always follow these safety precautions to avoid injury and damage to Storage Center equipment.
If equipment described in this guide is used in a manner not specified by Dell, the protection provided by the equipment could be
impaired. For your safety and protection, observe the rules described in the following sections.
NOTE: See the safety and regulatory information that shipped with each Storage Center component. Warranty
information is included as a separate document.
Installation Safety Precautions
Follow these safety precautions when installing an SC460 expansion enclosure:
•
You can install the expansion enclosure chassis without using a mechanical lift if you remove the drives, cooling fans, power
supply units (PSUs), and enclosure management modules (EMMs) from the chassis before installing it.
You must use a mechanical lift to install the expansion enclosure chassis if you do not remove the drives, cooling fans, PSUs, and
EMMs from the chassis.
•
Dell recommends that only individuals with rack-mounting experience install an SC460 expansion enclosure in a rack.
•
When installing multiple expansion enclosures in a rack, fill the rack from the bottom up and empty the rack from the top down.
•
The rack construction must support the total weight of the installed expansion enclosures. The design should incorporate
stabilizing features suitable to prevent the rack from tipping or being pushed over during installation or in normal use.
Caution
Equipment exceeds 90 kg (200 lb). Use appropriate lifting methods when installing an
SC460 expansion enclosure.
3
Advertisement
Table of Contents
