Canon HD XS HJ14ex4.3B Operation Manual page 41

5-1-5. Shuttle-Shot Function
This function allows you to switch between the current zoom position and the preset zoom position at the
maximum speed.
Current zoom position
Before using shuttle-shot function, the shuttle function must be assigned to the VTR, RET, or AUX
switch of the drive unit, or the AUX1 or AUX2 switch on the zoom demand. This manual describes the
"Shtl" function assigned to the VTR switch. For details, refer to "5-6 SWITCH OPERATIONS".
Setting the shuttle memory position
Zoom Rocker Seesaw
"MEMO" Switch
The operation with the Shtl switch is given the priority over that with the zoom rocker seesaw. The operation
with the zoom rocker seesaw is disabled while the Shtl switch is pressed.
5-1-6. Speed Preset
This function allows you to call the preset zoom speed any time you zoom. Assign the "Sped" function to
the VTR, RET, or AUX switch of the drive unit, or AUX1 or AUX2 switch on the zoom demand. This manual
describes the "Sped" function assigned to the VTR switch.
1. Storing the zoom speed and direction
Zoom Rocker Seesaw
"MEMO"
Switch
The "Shtl"
switch is
held down.
Max
speed
Shuttle memory position
"Shtl" Switch
"Sped" Switch
The "Shtl"
switch is
released.
Max
speed
Zoom to the position that you want to store. Keeping this
position, press the Shtl switch while holding down the
MEMO switch.
The "position" you stored here is different from the one
you set in "Framing Preset" mentioned later. The stored
position set here is retained even after the power is
turned off.
Operate the zoom rocker seesaw to determine the zoom
speed and direction (toward the telephoto angle or the wid-
est angle) which you want to store, and press the MEMO
switch while holding this position.
The stored zoom speed is applied to the "Framing Pre-
set".
E9
5 OPERATION
Previous zoom position