Hitachi 50UHDSM8 Owner's Manual page 44

Menus (Cont.)
Wired Network Setup
Set up a Wired connection automatically
Use the Automatic Network Setup when connecting your TV to a network
that supports DHCP.
1. Connect your TV to your LAN as described in the previous section.
2. Turn on your TV, press the
buttons to select 'Network'.
3. Press the OK or
the Network type as 'Wired'.
4. Select the IPv4 or IPv6 setting, then press the OK button to proceed.
5. Set the IPv4 or IPv6 setting to Auto.
6. Select Connect and press OK to connect the internet. The TV will
automatically pick up network information and connect. You will see an
'OK' confirmation once connected.
Set up a Wired connection manually
Use the Manual Network Setup when connecting your TV to a network that
requires a Static IP address.
1. Follow steps 1-4 in the "How to set up automatically" procedure.
2. Set the IPv4 setting to Manual.
3. Press the
then use the number buttons on the remote control or on-screen to input
the network parameters, such as IP Address, Subnet Mask, Gateway,
DNS1 and DNS2. Press the
4. When done, select Connect and press OK to connect the internet.
NOTE: IP, Subnet Mask, Gateway and DNS address field numbers must be
between 0 and 255. If you manually set the IP address, you must not use the
same IP address for any other device.
Tips for Network Connection:
• Use a standard LAN cable (Cat 5 or better with a RJ45 connector).
• Many network connection problems during set up can often be fixed
by re-setting the router or modem. After connecting the TV to the home
network, quickly power off and/or disconnect the home network router or
cable modem. Then power on and/or connect it again.
44
MENU button on your remote, use the
button to enter. Then press the
/ buttons to highlight the field you want to change, and
MENU button to return.
/ button to select
After Sales Support
Telephone:
Email: info@tempo.org
/
1300 886 649