Installation; Noises - Zanussi ZFC51400WA User Manual

for household appliances (the maximum
power is shown on the lamp cover).
3. Connect the mains plug to the mains
socket.
4. Open the lid. Make sure that the lamp
comes on.

Installation

WARNING!
Refer to Safety chapters.
Positioning
CAUTION!
If you are discarding an old
appliance that has a lock or catch on
the lid, you must ensure that it is
made unusable to prevent young
children being trapped inside.
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Service Centre

Noises

There are some sounds during normal running (compressor, refrigerant circulation).
10
The appliance shall have the plug
accessible after installation.
Electrical connection
• Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
• The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not
observed.
• This appliance complies with the E.E.C.
Directives.
Ventilation requirements
The airflow behind the appliance must be
sufficient.
1. Put the freezer in horizontal position on a
firm surface. The cabinet must be on all four
feet.
2. Make sure that the clearance between the
appliance and rear wall is 5 cm.
3. Make sure that the clearance between the
appliance and the sides is 5 cm.
www.zanussi.com