Table of Contents
Advertisement
6. Pairing
Pairing must be performed before the headphones can be used to listen to music
or communicate using a Bluetooth device.
For further details regarding the pairing procedure, consult the user's manual for
your Bluetooth device.
(1)
Remove the left and right earphones (units) from the charging case.
1
(2)
Press the multifunction button on the left side until the mode becomes
pairing mode.
• The state when the LED lamp flashes blue and red alternately is pairing mode.
When it lights alternately, release the multifunction button.
(3)
Press the multifunction button on the right side until the blue LED lights
and then flashes.
• When the blue LED on right earphone flashes three times, the power turns on
and the right earphone pairs with the left earphone automatically. (If there is
another connection device nearby, paring of the left and right units may not be
possible.)
L
• When in the pairing mode, if pairing is not completed within about 10
minutes,the power will automatically turn off.
(4)
Turn on the power to the Bluetooth device you wish to pair with, and
begin pairing; search for this unit (wireless headphones) from the paired
Bluetooth device.
• Set the Bluetooth device close (within one meter) to the wireless headphones.
• These wireless headphones will appear in the Bluetooth device's display as
«SE-E8TW».
(5)
Confirm that pairing has been successfully completed with the
device.
2
R
3
• Look at the display for the Bluetooth-enabled device and select "SE-E8TW".
• When the LED lamp is flashing in blue slowly about once every 3 seconds, pair-
ing is complete.
Connect to the
• Turn on the power of each of the left and right units and perform the connection
operation on the other Bluetooth device.
When the power of the units turns on, the blue LED flashes three times.
• Depending on the device, connection between the wireless headphones and
Bluetooth device may be effected automatically after pairing.
Disconnecting from the
• Press the multifunction button on either the right or left unit until the red LED
flashes three times to turn off the power.
If the operation is performed on one of the units, the power of both the left and
right units will turn off.
Note
• With some Bluetooth devices, the volume level may be maximized when pairing
with these earphones. Pairing should only be done while holding the earphones
in your hand. If you have these inserted in your ears during pairing you may be
subjected to loud volume causing possible hearing damage. After pairing adjust
the volume level down, using the Bluetooth device prior to placing earphones in
your ears.
• Depending on the device connected, the A2DP profile may need to be des-
ignated when playing music, and the HFP or HSP profiles for hands-free
communication.
• For details regarding operating and setting methods, consult the user's manual
for the Bluetooth device.
• When a connection with the device becomes no longer possible, perform paring
again.
• These wireless headphones can record pairing information for up to 2 Bluetooth
devices. If pairing is performed for a 3 device, the information for the first paired
device will be overwritten and lost. If you wish to reconnect to that device on a
subsequent occasions, it will be necessary to repeat pairing with that device.
• Whenever using a device with which pairing has been performed, first turn on
the power to the wireless headphones, then perform the connection operation
for the paired Bluetooth device.
Bluetooth
5
En
Bluetooth
device
Bluetooth
device
Hide quick links:
Advertisement
Table of Contents
