Product Overview; Specifications; Operation; Installing And Removing The Attachment - Toro TX 1000 Operator's Manual

Product Overview

1. Fork
2. Adjustable-forks frame

Specifications

Note:
Specifications and design are subject to
change without notice.
Overall width
Overall length
Overall height
Weight
Fork length
Fork cross-section size
Fork with adjustment range
(outside to outside dimensions)
Load rating capacity (per SAE
J1197)
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
Figure 4
3. Upper frame
80 cm (31 inches)
115 cm (45 inches)
69 cm (27 inches)
103 kg (226 lb)
91 cm (36 inches)
10.2 x 3.2 cm (4.0 x 1 inches)
23 to 76 cm (9 to 30 inches)
272 kg (600 lb)

Operation

Installing and Removing
the Attachment
Refer to the Operator's Manual for the traction unit for
the installation and removal procedure.
Important:
Before installing the attachment,
position the machine on a level surface, ensure
that the mount plates are free of any dirt or debris,
and ensure that the pins rotate freely. If the pins
do not rotate freely, grease them.
Note:
Always use the traction unit to lift and move
the attachment.
WARNING
If you do not fully seat the quick-attach
pins through the attachment mount plate,
the attachment could fall off the machine,
g001354
crushing you or bystanders.
Ensure that the quick-attach pins are fully
seated in the attachment mount plate.

Transport Position

When transporting a load, keep the attachment as
close to the ground as possible, no more than 15 cm
(6 inches) above the ground. Tilt it rearward to keep
the load level.
1. No more than 15 cm (6
inches) above the ground
6
Figure 5
2. Tilt the load rearward
g242374