Makita DF002G Instruction Manual
Hide thumbs
Also See for DF002G:
- Instruction manual (75 pages) ,
- Instruction manual (77 pages) ,
- Instruction manual (57 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita DF002G
Summary of Contents for Makita DF002G
- Page 1 INSTRUCTION MANUAL Cordless Driver Drill DF002G Read before use.
-
Page 2: Specifications
SPECIFICATIONS Model: DF002G Drilling capacities Steel 13 mm Wood Auger bit: 38 mm Self-feed bit: 38 mm Hole saw: 51 mm Fastening capacities Wood screw 10 mm x 90 mm Machine screw No load speed (RPM) High (2) 0 - 2,200 min... -
Page 3: Ec Declaration Of Conformity
Do not abuse the cord. Never use the cord for WARNING: The vibration emission during carrying, pulling or unplugging the power tool. actual use of the power tool can differ from the Keep cord away from heat, oil, sharp edges declared value(s) depending on the ways in which or moving parts. -
Page 4: Cordless Driver Drill Safety Warnings
Battery tool use and care Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. Use power tools only with specifically desig- nated battery packs. - Page 5 It will also void the Makita warranty for the Makita tool and Do not expose battery cartridge to water charger. or rain.
-
Page 6: Tips For Maintaining Maximum Battery Life
Tips for maintaining maximum CAUTION: Always install the battery cartridge battery life fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to Charge the battery cartridge before completely you or someone around you. discharged. -
Page 7: Overload Protection
Electric brake This tool is equipped with an electric brake. If the tool consistently fails to quickly stop after the switch trigger is released, have the tool serviced at a Makita service center. ► 1. Reversing switch lever 7 ENGLISH... -
Page 8: Speed Change
To change the speed, switch off the tool first. Push the Speed change speed change lever to display "2" for high speed or "1" for low speed but high torque. Be sure that the speed change CAUTION: Always set the speed change lever lever is set to the correct position before operation. -
Page 9: Installing Hook
Installing driver bit holder ASSEMBLY Optional accessory CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit/drill bit ► 1. Driver bit holder 2. Driver bit Fit the driver bit holder into the protrusion at the tool foot on either right or left side and secure it with a screw. -
Page 10: Screwdriving Operation
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES NOTE: When driving wood screw, pre-drill a pilot hole 2/3 the diameter of the screw. - Page 12 Makita Europe N.V. Jan-Baptist Vinkstraat 2, 3070 Kortenberg, Belgium Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan 885844A223 www.makita.com 20200911...