Maintenance - Husqvarna PG 540 Operator's Manual

3. Lock the weight to the weight holder with the locking
pin (A).
A
4. Fold the ring (B) on the locking pin on to the cylinder.
To adjust the weights
WARNING: Be careful when you adjust the
weights. The moving parts can cause injury.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
To do before the maintenance
• Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
• Use approved respiratory protection. The dust from
the product is dangerous to your health.
• Park the product on a level surface.

Maintenance

Do a check of the ON/OFF switch.
Do a check of the attachment points and the lock function for the handle.
16
• Move the weight to a selected position with the
weight handle. Refer to
B
Maintenance
• Stop the motor and disconnect the power plug to
prevent accidental start during maintenance.
• Clean the area around the product from oil and dirt.
Remove unwanted objects.
• Set out clear signs to give a warning to bystanders
that maintenance work is in progress.
• Keep fire extinguishers, medical supplies and an
emergency phone near.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
WARNING: Always make sure that the
weight lock locks correctly when the weights
are put in the selected position.
Weights on page 15 .
Daily Weekly
*
*
1211 - 003 - 22.01.2020
Each
Each 6
12-36
months
months