Husqvarna QTB380W User Manual page 32

32 www.husqvarna-electrolux.se
Problem
The lid does not close com-
pletely.
The lid is difficult to open.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after press-
ing the SUPER, or after
changing the temperature.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Food packages are blocking
the lid.
There is too much frost in
the appliance.
The lid gasket is dirty or
sticky.
The lamp is defective.
Temperature is set incorrect-
ly.
Large quantities of food to
be frozen were inserted at
the same time.
The room temperature is too
high.
Food placed in the appli-
ance was too warm.
The lid is not closed proper-
ly.
The SUPER function is
switched on.
The lid is not closed properly
or the gasket is deformed/
dirty.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
The temperature regulator is
not set correctly.
Solution
Arrange the packages in the
right way.
Defrost the appliance. Refer
to "Care and cleaning/
Defrosting the appliance"
chapter.
Clean the lid gasket.
Contact the Authorised
Service Center to replace
the LED light.
Refer to "Control panel/
Temperature regulation"
chapter.
Wait a few hours and then
check the temperature
again.
Refer to the climate class
chart on the rating plate or
to the "Installation/Position-
ing" chapter.
Allow food to cool to room
temperature before storing.
Check if the lid closes prop-
erly and the gaskets are not
damaged or dirty.
Refer to "Control panel/SU-
PER function" chapter.
Check if the lid closes prop-
erly and the gaskets are not
damaged or dirty.
Refer to "Control panel/
Temperature regulation"
chapter.
The compressor starts after
a period of time.
Set a higher/lower tempera-
ture.