4-10
Dell PowerEdge 4100/180 and 4100/200 Systems Service Manual
hard-disk drive
connector
screw (4)
Figure 4-9. Hard-Disk Drive Removal
5. Remove the four mounting screws that attach the hard-disk drive to the
carrier.
6. Disconnect the hard-disk drive from the connector on the back of the
carrier, and lift the drive from the carrier.
CAUTION: When disconnecting the hard-disk drive from the con-
nector, grasp the connector, not the cable, to avoid damaging the
connector.
After you replace the drive and reinstall the carrier in the bay, turn on the sys-
tem. The online indicator (green) lights, indicating power is being supplied to
the hard-disk drive. With the controller connected, the activity LED is activated
when the controller spins up the drive.
carrier