D-Link DAP-1950 Quick Installation Manual

Quick Installation Guide
DAP-1950
AC1900 High-Performance Mesh Wi-Fi Range Extender
INSTALLATION
OPTION 1
D-LINK WI-FI APP SETUP
1
Download the D-Link Wi-Fi app and launch it.
/
D-Link Wi-Fi
2 Tap Install New Device. Scan the QR code on the Quick
Installation Card. Follow the on-screen instructions to complete
/
the setup.
D-Link Wi-Fi
Model Name: DEVICE
Wi-Fi Name: dlink-XXXX
SETUP QR CODE
Password: XXXXXXXX
S/N: 123456789
PACKAGE CONTENTS
• DAP-1950 || AC1900 High-Performance Mesh
Wi-Fi Range Extender
• Quick Installation Guide
• Quick Installation Card
OPTION 2
1
Plug your Range Extender into an available outlet near your wireless
router and wait until the Status LED is blinking amber (this may take
/
up to 3 minutes). You can move it to a more suitable location after it
is set up. If the status LED does not light up, ensure the power toggle
switch underneath is in the "on" position.
2
Press the WPS (Wi-Fi Protected Setup) button on your wireless
/ router for 3 seconds. An LED should start blinking on your router. If
it does not blink, see the important note below.
3
Once confirmed that the WPS light is
/
blinking on your router, within one minute,
press the WPS button on your Range
Extender for 2-3 seconds. The Status LED
should start to blink green.
4
When the Status LED turns solid green (may take up to 3 minutes),
/ this indicates that your Range Extender is securely connected to
your wireless router.
Your setup is complete! You can now unplug and move your Range Extender to
a location between your Wireless Router and the area where you want wireless
coverage. By default, your Range Extender will share the same Wi-Fi name and
password as your Router.
If after moving your Range Extender, the signal strength indicator is showing one
single amber bar or if your Range Extender LED does not turn solid green within 3
minutes, move your Range Extender to a wall outlet closer to your wireless router.
IMPORTANT
WPS may be disabled on some Routers or Modems. If the WPS Status LED on your Router or
Modem does not start blinking when you have pressed the WPS button, try again and hold
it a little longer. If it still does not blink, STOP, and configure your Range Extender using
Option 1: D-Link Wi-Fi App Setup.
QUICK WPS SETUP
WPS
Button