Sony ClearScan25 SPP-M100 Operating Instructions Manual page 25

Symptom
You hear five short beeps and
can't store a speed dialing
number.
You hear five short beeps when
you try to make a speed dialing
call.
Speed dialing is incorrect.
The handset doesn't ring when
calling from the base unit.
The CHARGE lamp doesn't
light up when you replace the
handset to the base unit.
The battery pack has a shorter
life.
Remedy
• Make sure you follow the procedure in storing the
number correctly (page 18).
• Make sure the number (including the tone and pause
digits) is fewer than 16 digits.
• You entered a dialing key to which no phone number
has been stored.
• Store a correct number (page 18).
• Set the RING ON/BATT SAVE switch to RING ON.
• The battery may have little or no power. Charge the
battery for more than 10 hours (page 10).
• Replace the handset to the base unit and reset the
digital security code (page 21).
• Extend the antenna of the base unit vertically.
• Move the handset closer to the base unit.
• Place the base unit away from noise sources (page 6).
• Wipe the charge terminals of the base unit and the
handset with a soft cloth or paper for better contact of
the charge terminals.
• Make sure the handset is placed on the base unit
properly.
• The power wasn't continuously supplied to the base
unit.
• The battery pack was charged less than 10 hours (due
to power failure, etc.).
Additional Information
25 EN