Naming Preset Stations; Tuning To Preset Stations - Sony STR-DH130 Operating Instructions Manual

5
Press .
The station is stored as the selected preset
number.
6
Repeat steps 1 to 5 to store
another station.

Tuning to preset stations

1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Press PRESET + or PRESET –
repeatedly to select the station.
Each time you press the button, you can
select a preset station as follows:
1 2 3
30
You can also press the numeric buttons to
enter the preset station. To tune to the
selection, press
Using the control buttons on
the receiver
1
Turn INPUT SELECTOR to select the FM
or AM band.
2
Press TUNING MODE repeatedly to select
"PRESET".
3
Press TUNING + or TUNING – to select the
preset station you want.
4 5 ... 27
29 28
.

Naming preset stations

1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Tune to the preset station you
want to create an index name
for (page 25).
3
Press AMP MENU.
4
Press V/v repeatedly to select
"NAME IN", then press
The cursor flashes and you can enter a
character.
5
Press V/v to select a character,
then press B/b to move the
input position backward and
forward.
You can enter up to 8 characters to name
the station.
Tips
• You can select the character type as follows
by pressing V/v.
Alphabet (upper case) t Numbers t
Symbols
• To enter a blank space, press b without
selecting a character.
If you made a mistake
Press B/b until the character you want to
change flashes, then press V/v to select
the correct character.
6
Press .
The name you entered is registered.
Note (Europe model only)
When you name an RDS (Radio Data System)
station and tune to that station, the Program Service
name appears instead of the name you entered.
or b.
GB
25