Specifications - Sony HT-DDW795 Operating Instructions Manual

If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy
the problem (page 20). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields
56
US

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6 ohm loads, both channels driven, from
120 – 20,000 Hz; rated 85 watts per channel
minimum RMS power, with no more than 1%
total harmonic distortion from 250 milliwatts
to rated output.
Amplifier section
Power Output
Stereo mode (rated) (6 ohms 1 kHz, THD 1%)
See
page 20
Surround mode
page 43
(6 ohms 1 kHz, THD 10%)
Surround mode
(6 ohms 100 Hz, THD 10%)
1)
2)
Inputs
Tone
Reproduction frequency range:
1)
85 W + 85 W
2)
(reference)
RMS output
FRONT:133 W
per channel
CENTER: 133 W
SURROUND: 133 W
per channel
2)
(reference)
SUB WOOFER: 135 W
Measured under the following conditions:
120 V AC, 60 Hz
Reference power output for front, center and
surround speakers and sub woofer. Depending on
the sound field settings and the source, there may
be no sound output.
Analog Sensitivity: 800 mV/
50 kohms
Digital (Coaxial) Impedance: 75 ohms
Gain levels ±6 dB, 1 dB step
28 – 20,000 Hz