Replacing The Battery; Operation; Troubleshooting; Cleaning And Maintenance - Silvercrest SDWP 8.5 A1 Operation And Safety Notes

Lcd writing tablet
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
Remove batteries / rechargeable batteries
if the product will not be used for a longer
period.
Risk of damage of the product.
Only use the specified type of battery /
rechargeable battery!
Insert batteries / rechargeable batteries
according to polarity marks (+) and (-) on the
battery / rechargeable battery and the product.
Use a dry lint-free cloth or cotton swab
to clean the contacts on the battery /
rechargeable battery before inserting!
Remove exhausted batteries / rechargeable
batteries from the product immediately.
Notes for coin / button cell
batteries
WARNING! Do not ingest the
battery, chemical burn hazard.
This product contains a coin / button cell
battery. If a coin / button cell battery is
swallowed, it can cause severe internal burns
in just 2 hours and can lead to death.
Keep new and used batteries away
from children. If the battery
compartment does not close
securely, stop using the product and
keep it away from children. If you think
batteries might have been swallowed or
placed inside any part of the body, seek
immediate medical attention.
P Replacing the battery
(see fig. A)
CAUTION! Use the above-indicated battery
types only. Failure to observe this advice may
result in damage to the product.
Open the battery compartment
turning the screw
6
small screwdriver then pull out the battery
compartment.
8
GB/IE/NI
by
7
anticlockwise with a
Replace with a new 3 V
battery. The marking "+" must face upwards.
Close the battery compartment
it by turning the screw
small screwdriver.
P Operation
Remove the stylus pen
of the writing pad.
Write what you want directly on the LCD
screen
with the stylus pen
1
Note: Please do not write on the LCD
screen
. In the worst case, sharp objects can
1
irreparably damage the LCD writing board.
When you want to rewrite on the writing pad ,
press the erase button
Ensure that the lock switch
position
.
The lock switch
4
button
to prevent losing content while you
5
are writing or drawing. After locking
erase button
, you can still write on the
5
writing pad.
P Troubleshooting
If the erase button
5
ensure that the lock switch
position. If the writing pad does not function
replace the battery as described in the "replacing
the battery" section.
P Cleaning and maintenance
Under no circumstances should you use
liquids or detergents, as these will damage the
product.
The product should only be cleaned on the
outside with a soft dry cloth.
type CR2025
and tighten
7
clockwise with a
6
from the top middle
2
.
2
to clear the content.
5
is in the unlock
4
function is to lock the erase
the
does not function , please
is in the unlock
4

Advertisement

Table of Contents
loading

Table of Contents