Summary of Contents for Mitsubishi Electric MSZ-BT Series
Page 1
Wi-Fi INTERFACE Model MSZ-LN Series (MAC-567IFB-E), MAC-567IF-E MSZ-AP Series (MAC-566IFB-E/MAC-567IFB2-E/MAC-577IF2-E) MSZ-EF Series (MAC-577IF2-E) MSZ-BT Series (MAC-577IF-E) SETUP MANUAL English(EN) KONFIGURATIONSHANDBUCH Deutsch(DE) MANUEL DE CONFIGURATION Français(FR) SETUPHANDLEIDING Nederlands(NL) MANUAL DE CONFIGURACIÓN Español(ES) MANUALE DI CONFIGURAZIONE Italiano(IT) ΕΓΧΕΙΡΙΔΙΟ ΡΥΘΜΙΣΗΣ Ελληνικά(EL) MANUAL DE CONFIGURAÇÃO Português(PT)
Introduction See the manuals of the system to be connected with the Wi-Fi interface to figure out which model of the Wi-Fi interface is connectable to it. MODE UNIT ● The figures hereafter show MAC-57 series as a representative. ● ATW (Air to water) is only compatible with MAC-567IF-E. RESET MODE MAC-56 series...
■ Ensure that the Router supports the WPA2- ■ This Wi-Fi interface should not be installed and AES encryption setting before starting the Wi-Fi connected to any Mitsubishi Electric system which is to provide application critical cooling interface setup. ■ The End user should read and accept the terms or heating.
3. Setting up 3-1. Initial state Initial state Turn on the breaker of the air conditioner or the ATW unit. After LED indication enters the initial state shown on right, the Wi-Fi interface can be paired with the Router. Refer to 4. LED pattern when LED indication does not enter the initial state. MODE OFF Note: It may take a few minutes to enter the initial state.
Page 5
3-3. Setting up in WPS-PUSH mode 1. Make sure that the LED indication is as shown below. Push WPS button of the Router within 2 minutes after the mode selection in 3-2. has completed. The WPS-PUSH mode will return to initial state in 3-1. if WPS button is not pressed for 2 minutes.
Page 6
3-4. Setting up in Access Point mode Complete the setting up in the Access Point mode within 10 minutes. (MAC-57 series only) 1. Make sure that the LED indication is as shown below. On the Wi-Fi Setting Screen on your smartphone, select SSID and enter KEY, which are printed on the label of the Wi-Fi interface.
3-5. Setting up WPS-PIN mode (MAC-56 series only) 1. Before using WPS-PIN mode, the PIN code of the Wi-Fi interface needs to be set on the Router. Refer to Router's manual to enter the PIN. 2. Push MODE switch for 14 seconds and release to set WPS-PIN mode. 3.
Page 8
Troubleshooting : ON : OFF : Flashing MODE UNIT Description (Orange) (Green) (Orange) (Green) Connection to MELCloud established, and Connection to indoor unit failed Connection to Router failed, and connection to indoor unit established Connection to Router failed, and starting up indoor unit connection Connection to Router failed, and connection to indoor unit failed Connection to MELCloud failed, and...
Page 9
Travellers Lane, Hatfield, Herts., AL10 8XB, England, U.K. Polish Branch Krakowska 50, PL-32-083 Balice, Poland MITSUBISHI ELECTRIC TURKEY ELEKTRİK ÜRÜNLERI A.Ş. Şerifali Mah. Kale Sok. No: 41 34775 Ümraniye, İstanbul / Turkey MITSUBISHI ELECTRIC (RUSSIA) LLC 115114, Russia, Moscow, Letnikovskaya street 2, bld. 1, 5th floor...
Page 10
MITSUBISHI ELECTRIC CONSUMER PRODUCTS (THAILAND) CO., LTD AMATA CITY CHONBURI 700/406 MOO 7, TAMBON DON HUA ROH, AMPHUR MUANG, CHONBURI 20000, THAILAND MITSUBISHI ELECTRIC AIR CONDITIONING SYSTEMS MANUFACTURING TURKEY JOINT STOCK COMPANY. MANISA OSB 4.KISIM KECILIKOYOSB MAH. AHMET NAZIF ZORLU BULVARI NO:19 YUNUSEMRE - MANISA.