11 Small plug 12 Storage pouch (S3232 only) Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Important safety information Read this important information carefully before you use the appliance and save it for future reference.
Page 23
English Danger - Keep the supply unit dry. Warning - To charge the battery, only use the detachable supply unit (type HQ8505) provided with the appliance. - The supply unit contains a transformer. Do not cut off the supply unit to replace it with another plug, as this causes a hazardous situation.
- Do not use the supply unit in or near wall sockets that contain an electric air freshener to prevent irreparable damage to the supply unit. Electromagnetic fields (EMF) This Philips appliance complies with all applicable standards and regulations regarding exposure to electromagnetic fields.
English General - This shaver is waterproof. It is suitable for use in the bath or shower and for cleaning under the tap. For safety reasons, the shaver can therefore only be used without cord. - The supply unit is suitable for mains voltages ranging from 100 to 240 volts.
Page 26
English S3232 Battery fully charged When the battery is fully charged, all charging lights light up white continuously. Note: After approx. 30 minutes, the charging lights go out to save energy. Battery low When the battery is almost empty, the bottom charging light flashes orange.
English Note: Depending on your shaving/styling behavior and beard type, the operating time may vary over time. Charging with the supply unit 1 Put the small plug in the appliance. 2 Put the supply unit in the wall socket. - The charging light shows the charging status of the appliance.
- Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. Switching the appliance on and off To switch the appliance on or off, press the on/off button once.
English 2 Move the shaving heads over your skin in circular movements to catch all hairs growing in different directions. 3 Stretch your skin with your free hand so the blades can lift and cut hair. Gently press the shaver onto you skin so the floating heads can follow the contours of your face.
Page 30
English 3 Rinse the shaving unit under the tap to ensure that it glides smoothly over your skin. 4 Switch on the appliance. 5 Move the shaving heads over your skin in circular movements to catch all hairs growing in different directions. Make sure each shaving head is fully in contact with the skin.
English 3 Hold the trimmer perpendicular to the skin and move the appliance downwards while you exert gentle pressure. 4 Switch off and clean the trimmer after each use. 5 Close the pop-up trimmer (‘click’). Cleaning and maintenance Cleaning the shaver Caution: Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the...
Page 32
English 4 Rinse the outside of the shaving unit with lukewarm water. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. 5 Carefully shake off excess water and let air dry completely. 6 Close the shaving unit.
English Thorough cleaning Clean the shaving heads thoroughly once a month for optimal performance. 1 Switch off the appliance and make sure it is disconnected from the wall socket. 2 Press the release button to open the shaving unit. Pull the shaving unit off the appliance. 3 Turn the lock anticlockwise (1) and remove the retaining frame (2).
Page 34
English 6 Put the cutter back into the guard. 7 Put the shaving heads back into the shaving unit. 8 Put the retaining frame back into the shaving unit (1) and turn the lock clockwise (2). 9 Insert the hinge of the shaving unit into the slot in the top of the shaver.
Replace damaged shaving heads immediately. Always replace the shaving heads with original Philips shaving heads (see 'Ordering accessories'). 1 Switch off the appliance and make sure it is disconnected from the wall socket.
Page 36
English 5 Place new shaving heads in the shaving unit. Note: Make sure that the shaving heads with the projections fit exactly onto the hooks of the shaving head holder when placing them. The shaving heads supplied with the shaver either have notches or projections.
English Ordering accessories To buy accessories or spare parts, visit www.philips.com/parts-and-accessories or go to your Philips dealer. You can also contact the Philips Consumer Care Center in your country (see the international warranty leaflet for contact details). Recycling - Do not throw away the product with the normal household waste at the end of its life, but hand it in at an official collection point for recycling.
Page 38
English Take any necessary safety precautions when you handle tools to open the appliance and when you dispose of the rechargeable battery. Be careful, the battery strips are sharp. 1 Press the shaving unit release button to open the shaving unit. Pull the shaving unit off the shaver.
Page 39
English 5 Lift out the front panel. 6 Bend the eight snap hooks aside and remove the cover of the power unit. 8× 7 Lift out the two parts of the power unit. 8 Break the battery tags with a pair of cutting pliers.
English Warranty and support If you need information or support, please visit www.philips.com/support or read the international warranty leaflet. Warranty restrictions The shaving heads (cutters and guards) are not covered by the terms of the international warranty because they are subject to wear.