1. Starting up the IE system without target board connected makes initial values for ports-indefinite.
2. The RESET value of the CANES register is not correct. As workaround the CANES register has to
be reset by software.
3. Meter Controller/Driver
Since an external transistor is used for the output driver, the electrical specifications of driver
capability vary as follows:
Table 5-1: Output Current per Terminal (effective value)
Note: For the device output current, see the data sheet.
4. Sound Generator
Since an external transistor is used for the output driver, the electrical specifications of driver
capability vary as follows:
Table 5-2: Output Current of P61 (SGO) (effective value)
Note: For the device output current, see the data sheet.
5. LCD Controller/Driver
It is necessary to set the LCDTM register (the ICE dedicated register).
6. Power Fail Detector
It is necessary to set the DAM0 register (dedicated register when the the ICE is used).
7. The voltage level of V
V
of the FLPMC register will be always read as 1.
PP
Chapter 5 Restrictions
High-level output current
Low-level output current
High-level output current
Low-level output current
cannot be detected during self-programming. The feedback information bit
PP
IE-78K0-NS-P04, IE-780828-NS-EM4
Device
ICE
-80 mA
-150 mA
80 mA
250 mA
Device
ICE
-20 mA
-150 mA
20 mA
250 mA
53