FLEXIDOME IP indoor 8000i
6
Hardware installation
Caution!
Do not remove the bubble to move the camera lens manually.
The lens system is motorized for easy commissioning. Moving these parts manually will break
!
the gears and damage the camera. In order to move or focus the camera lens, always use the
motorized PTRZ controls mentioned in this manual. Removal of the bubble is only allowed for
bubble replacement.
6.1
Installing the mounting plate
The mounting plate is used to fix the camera to a flat surface. It offers different holes and
slots for a variety of fixing options.
Installation options
The camera has two configurations for surface mounting:
–
–
Bosch Security Systems B.V.
3
5
1 10.2 cm / 4 in. Square junction box
3 Single gang box or universal slot,
45 mm / 1.8 in to 85 mm/3.3 in
5 Ceiling/wall mount and pendant
interface plate (NDA-8000-PIP)
Refer to Installing the mounting plate without conduit, page 14 , if the wires are not on
the outside of the surface.
Refer to Installing the mounting plate with conduit, page 15 , if the wires are on the
outside of the surface.
2 Pole mount (NDA-8001-PLEN/
4 Double gang box
Installation manual
Hardware installation | en
NDA-8001-IC/NDA-U-PMAL/NDA-U-
PMAS)/Corner mount (NDA-U-CMA)
13
2021-08 | 01 |