Husqvarna DM220 Workshop Manual page 24

13
The tools listed below are available from Husqvarna.
l
510 22 11-01
Special socket
Tool Necessary for adjusting the
l
intermediate shaft's slip clutch.
1/2 inch socket wrench attach-
ment.
Workshop wrench, Hex
Universal use.
l
502 50 19-01
3 mm
502 50 18-01 4 mm
502 50 64-01 5 mm
504 90 00-01
6 mm
502 71 27-02
Workshop wrench, Torx T27
Universal use.
l
504 90 00-06
Workshop set,
mm-dimensions
Universal use.
l
Hex: 3, 4, 5 and 6 mm
Socket: 8 mm
504 90 90-02
Universal puller
Bearing dismantling.
l
531 00 48-67
Bearing puller
Removal of spindle shaft's front
l
bearing.
582 11 04-01
Service tool
Necessary for adjusting the
l
intermediate shaft's slip clutch.
TOOLS
= Service operation
The special tools below are needed for service work to DM 220
but are not sold by Husqvarna.
Lock ring pliers
Make: Milbar/Imperial IR-15R.
Pliers for small lock rings
without eyes.
Dismantling and fitting of the
l
spindle shaft's lock ring.
Counter stay device
There are a number of manufac-
turers, e.g.: Kukko (Germany),
Snap-On (USA).
Dismantling of ball bearings
l
and needle bearings in gear
housing and gear box cover.
Removal of oil seals (radial
l
seals).
Multimeter
Make: Amprobe 37XR-A.
One of few universal instru-
ments that can also measure indu-
ctance (H, Henry).
Check of electric motor's
l
functions.
24