Page 1
Gas hob PNH6B6B90A This cooktop is approved for use with Natural Gas and Universal LPG. Leave these instructions with the owner. USER INSTRUCTIONS INSTALLATION INSTRUCTIONS MAINTENANCE INSTRUCTIONS...
Additional information on products, accessories, maximum height of 2000 metres above sea replacement parts and services can be found at level. www.bosch-home.com and in the online shop www.bosch-eshop.com Do not use lids or hob guards for children which are not recommended by the hob manufacturer.
Important safety information This appliance is not intended for use by (Important safety persons (including children) with reduced information physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or D O NOT MODIFY THIS APPLIANCE. I m p o r t a n t s a f e t y i n f o r m a t i o n instruction concerning use of the appliance by DO NOT USE OR STORE FLAMMABLE...
Important safety information What to do if you smell gas Warning – Risk of fire! The cooking process must be supervised. A ■ Do not try to light the appliance. short cooking process must be supervised ■ Do not touch any electrical switch; do not without interruption.
Installation and connection 5Installation and connection S tatutory requirements I n s t a l l a t i o n a n d c o n n e c t i o n This installation must conform with the following: Manufacturer’s Installation instructions ■...
Installation and connection Clearances Installation of cooktop into the kitchen bench A range hood fitted above the top must be installed according to the installation instructions for the range Side clearances: If the distance measured from the hood. A minimum distance of 650 mm is required for a periphery of the nearest burner to any vertical surface is range hood and 750 mm for an exhaust fan.
Installation and connection This appliance must be earthed. When connecting Fit regulator (N.G.) or a test point (Universal LPG) ■ the cooktop ensure that the earth wire is connected directly to the R 1/2’’ connection. first and that all wires are connected to the correct terminals.
Installation and connection Before Leaving Check all connections for gas leaks with soap and water. DO NOT use a naked flame for detecting leaks. Ignite all burners both individually and concurrently to ensure correct operation of gas valves, burners and ignition.
Getting to know your appliance *Getting to know your appliance B urner locations G e t t i n g t o k n o w y o u r a p p l i a n c e Burner parts Ignition plug Thermocouple Burner cup...
Gas burners An orange-coloured flame is normal. This is caused by ÄGas burners the presence of dust in the atmosphere, spilt liquids, etc. In the event of the burner flames being accidentally S witching on manually extinguished, turn off the burner control and do not G a s b u r n e r s attempt to re-ignite the burner for at least one minute.
Cleaning and maintenance Always centre the pan 2Cleaning and maintenance over the burner, not to one side. Otherwise it could tip over. C leaning Do not place large pans C l e a n i n g a n d m a i n t e n a n c e Once the appliance is cool, use a sponge to clean it on the burners near the with soap and water.
Trouble shooting 3Trouble shooting D O NOT MODIFY THIS APPLIANCE. T r o u b l e s h o o t i n g Only authorized personnel from the Service Centre are qualified to work on the appliance. Sometimes certain faults detected can be easily resolved.
Customer service 4Customer service W hen contacting our customer service, please provide C u s t o m e r s e r v i c e the product number (E-Nr.) and production number (FD) of the appliance. This information is given on the specifications plate located on the lower section of the hob and on the label in the user manual.