Table of Contents
Advertisement
Projection relationships (continued)
Note
z When [GEOMETRY] is used, the focus of the entire screen may be lost as correction
increases.
z Adjustment range of the [GEOMETRY] items may not match the listed projection range
depending on the projection lens. Use this projector within the projection range, otherwise
the correction may not work.
z The geometric adjustment function cannot be used when the video signal in simultaneous
format or the video signal with vertical scanning frequency of 100 Hz or 120 Hz is input.
When projecting an image in simultaneous format or an image with vertical scanning
frequency of 100 Hz or 120 Hz, install the projector following the instructions below so that
distortion does not occur in the projected image.
- Use a flat screen.
- Install the projector so that the front side of the projector is parallel to the screen.
- Install the projector so that the image can be projected within the lens shift adjustment
range.
ENGLISH-11
Advertisement
Table of Contents
