Information On The Display Panel - Bosch WNA134U8GB Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Faults and what to do about them
en

Information on the display panel

Display
Õ
•©£
r
E lights up
The symbol Û
flashes
E:36
alternating with
-10
E:35
alternating with
-10 (Suitable for spe-
cial models)
H:95
alternating with
"Ÿš
when programme is
finished
46
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
Close the door, continue the programme with A Start/Reload button or
select [ Drain.
Flashes slowly: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
The temperature in the drum is too high. Wait for the appliance running to cool
down the laundry till the •©£ disappears on the display panel, then the door can
be opened.
Flashes (no water supply): Water tap turned on? Filter in the water supply is
blocked? ~ "Filter in the water supply is blocked" on page 44
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
The childproof lock is activated – deactivate it.
Run the Cottons i 90°C programme to clean and care for the drum and the
outer tub.
Notes
Run the programme without laundry.
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
Switching the drum care information signal on/off. ~ Page 40
Drain pipe or water drain hose is blocked. Clean the drain pipe and the water
outlet hose.
Drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe
and water drain hose are not kinked or trapped.
The drain pump is blocked.
~ "Drain pump is blocked" on page 43
The drain hose at the siphon is blocked.
~ "The drain hose at the siphon is blocked" on page 44
The water drain hose is connected too high. Install the water outlet hose at a
maximum height of 1 meter.
~ Page 16
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
No water detected in drying phase, may get bad drying result.
~ "Filter in the water supply is blocked" on page 44

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents