Disassembly & Reassembly - Dell 1700FP Service Manual

Color monitor
Table of Contents

Advertisement

3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
1700FP monitor.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
3-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
3-1-1 Removing the Stand
1. With a pad beneath it, stand the monitor on its
front with the screen facing downward and
the base close to you. Make sure nothing will
damage the screen.
2. Working from the back of the monitor remove
the Round Hinge Cover and the Stand Cover.
3. Remove the 6 screws on the Hinge.
Caution: Be careful. The signal cable and
power cable are still attached to the
monitor.
5. Disconnect the Power Cord and Signal Cable.
3-1-2 Main Body Disassembly
1. Remove 4 screws on the Rear Cover.
2. Pull the Rear Cover up and off the monitor.
3. Remove 19 screws on the PCB Shield and
remove the Shield.
4. Remove 5 screws on the Main PCB and 2
screws on the Inverter PCB and 2 screws on
the 10P Harness.
3-2 Reassembly
Reassembly procedures are in the reverse order of Disassembly procedures.
1700FP
5. Disconnect the interface wire (31P) between
the Panel and the CN2 connector on the Main
PCB.
6. Disconnect the Function PCB wire (10P)
between the Function PCB and the CN10
connector on the Main PCB.
7. Disconnect 2 Inverter wires (12P) between the
Panel and the CN1 connectors on the Inverter
PCB.
8. Carefully lift the Main PCB Assembly and
Inverter PCB and place them on a flat, level
surface that is protected from static electricity.
9. Remove 10 screws on the PCB Bracket.
10. Remove the Bracket Assembly from the Front
Cover.
11. Remove the 2 screws on the Function PCB
from the Front Cover and remove the
Function PCB and Function Knob.
12. Remove 4 screws on the Front Shield and
remove the PCB Bracket and the Front Shield.
3-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents