Table of Contents
Advertisement
Network settings
1
Press
and use
to select Setup then press OK.
2
Use
to select Network settings, then press OK.
3
Adjust the following items.
Manual network settings
1
Use
to select Manual network settings, then press OK.
Manual network settings
Network selection
Connection test
Wireless network setting
Setting status
IP configuration
Proxy configuration
Home network
Wake-on-LAN(DIAL)
Net TV
Samba interactive TV settings
Reset network settings
Manual network settings
Network selection
Connection test
Wireless network setting
Setting status
IP configuration
Proxy configuration
Home network
Wake-on-LAN(DIAL)
Net TV
Reset network settings
Network selection
2
Use
to select Network selection, then press OK.
3
Use
to select the desired setting, then press OK.
If you connect to an Ethernet cable, select
Wired
Wired to connect to the internet.
If you have a router with easy connect function,
Wireless
select Wireless to connect to the internet.
Wireless network setting
This menu is displayed only when you set Wireless in Network
selection. In order to use a wireless network, you must set up a
connection to the AP (e.g. wireless router).
2
Use
to select Wireless network setting, then press OK.
Auto
Search for wireless networks automatically and select the SSID from
the list.
3
Use
to select Auto, then press OK.
4
The list of wireless networks will be displayed. Use
the appropriate the SSID, then press OK.
Auto
Router 1
Manually enter your SSID
Router 2
Router 3
Router 4
If you select the SSID with
will appear. Enter the WEP
wireless network using
If you select the SSID has an easy connect, the easy connect
setting screen will appear. Use
press OK.
Select this setting if your router has an easy
connect button. Start scanning for wireless
networks on the TV after pressing the easy
Easy Connect
connect button on your router. If connection
test fails, try Easy Connect again.
refer to the router's manual for more details.
Select this setting if your router has an easy
connect feature but does not have an easy
connect button. Enter the 8-digit PIN code
Pin code
shown on your TV in the Router settings menu
via PC before Connect is selected.
If your wireless network with authentication
setting (WEP
Manual
entry screen will appear. Enter the WEP
others key of the selected wireless network
using
Easy Connect cannot be used when the security protocol is set
*1
to WEP. Change the Access Point's security mode from WEP to
others (recommended).
WEP is not recommended to be used due to its major security
*2
flaws. Change the security protocol on the wireless router to
others (recommended) mode.
Confirmation message will appear. Select OK to complete the settings.
Note(s)
For a wireless network with authentication setting, key icon appears to the
right hand of the SSID.
Signal icon shows the strength of the signal.
WEP
*2
/ others key appears as asterisks on the confirmation screen.
The wireless LAN supports following specifications.
Wireless standards: IEEE 802.1 1 a/b/g/n/ac
–
Frequency spectrum: 2.4GHz / 5GHz
–
Security protocol: WEP
*2
/ others
–
42
to select
Manual
Easy Connect
Pin code
*2
, WEP
/ others Key entry screen
*2
/ others key of the selected
, then press OK.
to select a setting, then
*1
If it fails then
*2
*2
, others), WEP
/ others Key
*2
/
, then press OK.
Continued on next page.
.
English
Advertisement
Table of Contents
