Advanced
The Advanced screen contains parameters involving your hardware devices. It also provides advanced
settings of the system.
FIR Ports
Configure the system's infrared port using options: Disabled and Enabled.
Insyde Software SCU
Main
Infrared Ports(FIR)
Parallel Port(LPT)
Legacy USB support
<Tab> <Right> <Left> for block select. <Up> <Down> for item select.
< Enter> for accept. <Cancel> <Esc> for reject. <Alt> activates accelerators.
<Space> for Enable or Disable.
The table below describes the parameters in the screen. Settings in boldface are the default and suggested
parameter settings.
FIR I/O Settings
DMA Setting for Fast
IR
Mode Setting
Chapter 2
Advanced
Security
---------------------------------FIR Ports--------------------------------
-----FIR I/O settings---
( ) Disabled
( ) COM1,3F8,IRQ4
( ) COM2,2F8,IRQ3
( ) COM3,3E8,IRQ4
( ) COM4,2E8,IRQ3
Description
Sets the base I/O address and IRQ for
Infrared port.
Sets a DMA channel for the printer to
operate in ECP mode. This parameter is
enabled only if Mode is set to ECP.
May 20, 2003 5:40:09
Boot
--DMA Setting For Fast IR--
( ) DMA1
( ) DMA2
( ) DMA3
OK
Cancel
Exit
-Mode Setting for IRDA-
( ) Normal (16550)
( ) IrDA (HPSIR)
( ) ASK IR
( ) FAST IR
Option
COM1, 3F8, IRQ4/ COM2,
2F8, IRQ3/ COM3, 3E8,
IRQ4/ COM4, 2E8, IRQ3
DMA1, DMA2, DMA3,
Normak (16550), IrDA
(HPSIR), ASK IR, FAST IR
48