Operating Instructions - DeWalt DXAM2818 Instruction Manual

In Canada, the use of a temporary adapter is not permitted by the
Canadian Electrical Code. Ensure that the air mover is connected to
an outlet having the same con guration as the plug. No grounding
adapter should be used with this appliance.
WARNING: This product can expose to chemicals including lead,
which is known to the State of California to cause cancer, birth defects
or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
WARNING:
•
An extension cord must have adequate wire size for safety.
•
When using more than one extension to make up the total length, be
sure each individual extension contains at least the minimum wire size.
•
Do not use to blow combustible explosive materials, such as coal, grain,
or other nely divided combustible material.
•
Never pick up explosive liquids (e.g. gasoline, diesel fuel, heating oil,
paint thinner, etc.), acids or solvents.
•
Some wood contains preservatives which can be toxic. Take extra care
to prevent inhalation and skin contact when working with these materials.
Request and follow any safety information available from the material
supplier.
•
Do not use air mover as a step ladder.
•
Do not place heavy objects on air mover.
WARNING:
To reduce exposure to chemicals, wear approved safety equipment
such as dust masks that are specially designed to lter out microscopic
particles.
WARNING:
Do not point the air mover at other people or any living thing.

OPERATING INSTRUCTIONS

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT USE THIS AIR MOVER WITH ANY SOLID-STATE
SPEED CONTROL DEVICE.
Follow these instructions to operate the air mover:
•
Unpack air mover from carton.
•
To use unit, place the unit in the area most suitable for the application.
Several factors need to be considered; the unit must be placed close
enough to an AC outlet to be plugged in, there must be a minimum
clearance of two feet from either side of the unit to allow for proper air ow,
and the unit should not be placed where it can become a tripping or safety
hazard.(see Figure A)
•
Use only on a level and stable surface to prevent air mover from falling and
possibly causing injury or damage to unit.
•
Place unit in the proper operating position for application. Refer to the
Operating Positions section in this manual.
•
Plug unit into the wall.
•
Turn unit on and select air speed by turning the switch, located near the
top handle, clockwise.
•
When drying job is completed, turn the unit off and follow the directions for
Storage in this manual.
Figure A
6
2ft