Advertisement
1.
Remove the pop-up stopper (E) and pop-up flange (F) from the pop-up
assembly.
2.
Apply adequate amount of plumbers putty underside of pop-up flange (F)
then insert pop-up drain assembly from underside of the sink and secure the
pop-up flange (F) from the top.
3.
Rotate the drain body so that horizontal rod hole faces back of the faucet.
Hold the pop-up assembly in place and tighten the locknut (G).
4.
Remove the excess putty. Connect the trap (H) (check manufacturer's instruc-
tions for installation).
5.
Remove rod nut (I).
6.
Ensure the washer (K) is in place (for brass pop-up only). Insert rod (J). Tighten
the rod nut (I).
7.
Push rod down to open drain. Insert the pop-up stopper (E) carefully. Test if the
pop-up stopper (E) is working properly.
8.
Connect pop-up bracket to the rod using clip (L). Tighten the thumbscrew (M)
to connect pop-up bracket to pop-up lift rod.
Pop-Up Drain Installation
4
Advertisement
