Removable Seat; Heated Seat - Yamaha SRS10ML53 Owner's Manual

To install the hood and access panels, use
the following procedure:
1. Position the hood onto the snowmo-
bile and connect the hood harness
connector and secure the two front
quarter turns.
2. Install the access panel into the skid
plate; then close the access panel
and secure with the two quarter
turns.

Removable Seat

To remove the seat, remove the torx-head
screw from the underside of the seat; then
lift on the back of the seat and move it up
and rearward to remove it.
CAUTION
Prior to removing the seat, lift the
rear of the seat and disconnect the
seat heater harness connector.
On S-TX DX 146 models, release the
lever securing the seat assembly; then lift
up and remove the seat. Make sure to dis-
connect the seat heater harness.
To install the seat, route the front tabs on
the seat base through the console; then
install the seat and secure using the torx-
head screw.
On S-TX DX 146 models, route the front
tabs on the seat base through the console;
then press down on the rear of the seat
until the rear latches.

NOTE: Prior to lowering and
securing the seat, connect the seat
heater harness connector.

Heated Seat

Some models are equipped with a heated
seat. Models with this option can be
adjusted with a HIGH and LOW switch
which will be located near the gas tank cap.
SNO-894A
0748-419
SNO-895A
SNO-766
12