Electrical Safety - Black & Decker SVA520B Original Instructions Manual

ENGLISH ENGLISH

Electrical safety

Symbols on the charger
Read all of this manual carefully before using
#
the appliance
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on
the rating plate.
$
Indication of polarity.
The charging base is intended for indoor use
only.
Labels on appliance
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before
using the appliance
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Dust bowl release button
3. Dust bowl
4. Chassis on/off power switch
5. Brush control switch
6. Upper handle
7. Main chassis
7a. Chassis release button
8. Floor head
9. Wall Mount
10. Charger
11. Brush tool accessory
12. Crevice tool accessory
8
8
(Original instructions)
Use
Switching on and off (Fig. A)
To switch on, press the on/off switch (1) located on the
u
handle of the main unit (1), or alternatively on the chassis
handle (4).
To switch off, press the on/off switch (1) or (4).
u
Using Accessories (Fig. B)
The appliance is supplied with a brush tool (11) and a
u
crevice tool (12).
Fit the chosen accessory into the front of the appliance as
u
shown in Figure B.
Fitting the upper handle to the main chassis
(Fig. C, D)
The stick vac chassis is supplied in 2 parts, the upper han-
u
dle (6) and the lower chassis (7), but they are connected
by a wire.
Slide the upper handle (6) into the main chassis (7) as
u
Ensure the wire is not trapped.
u
u
(Fig. E)
u
Fitting the vacuum to the Chassis
(Fig. F, G)
u
To release the vacuum from the chassis press the chassis
u
release button (7a) and lift clear.
The appliance can now be operated via the on/off button
u
(4) on the handle (6). This also allows you to utilise the
beater bars via the 'brush on' control (5) as shown in
Charging (Fig. H, I)
Make sure the appliance is switched off. The battery will
u u
not be charged with the on/off switch in the on position.
Plug the jack end of the charger (10) into the back of the
u
vacuum, then plug the charger into an outlet as shown.
While charging, if the battery is fully discharged, only
u
the bottom led will flash the charging indicator (14) . As
the battery charges the LEDs will illuminate one by one
and remain lit until all four will be lit. They will remain lit
for 10 seconds when fully charged and then turn OFF.
If the battery is not fully discharged when charging begins
the LED nearest the fully lit LED on the charging indicator