Page 2
Attach battery pack Remove backing paper from Velcro strips and stick Velcro to back of router and to back of battery pack as shown. Press the Velcro together to attach battery pack to router. The Velcro allows the battery pack to be easily removed and reattached.
Page 4
Mark positions of dowels Layout dowel positions on boards to be jointed. Clamp board to machine With layout marks on top, clamp board to be jointed onto sliding bar flush with underside of base plate. Position for dowel hole Loosen star knob to free router movement. Power feed board and position router so that center of cross hair is positioned on location for dowel.
Page 5
Plunge bit Turn on router and plunge bit to depth stop to cut dowel hole. Repeat for remaining dowels Repeat above procedure to drill any additional dowel holes in the board. Mark position of dado cut We will use a dovetail bit to cut a stopped dado for a sliding dovetail.
Page 6
Position for dado Loosen star knob to free router movement. Position board and router so cross hair line of laser overlays line marking dado location. Tighten star knob. Set plunge depth Zero bit on top of board. Use brass gauge bar to set router depth stop to desired depth for the dado cut.