Black & Decker NW7220 Manual page 7

Fig. A
Wet/Dry foam insert
6.
7.
Fig. B
8. Squeegee
Installation
The product can be attached to a wall to provide a convenient
storage and charging point for the appliance.
suitable for the wall type and is appropriate to the weight of
the appliance.
Mark the location of the screw holes (within reach of an
u
electrical outlet for charging the vac while it is on the wall
bracket).
Fix the mounting bracket to the wall using appropriate
u
scres and plugs for the type of wall and weight of the ap-
pliance.
Hang the appliance on the wall by placing the opening
u
on the base of the vac over the hooks in the wall mount
charging bracket.
Assembly
These models may be supplied with some of the following
accessories:
A squeege tool (8) for wet use on hard surfaces.
u
Fitting (Fig. D)
Insert the appropriate accessory into the front of the appli-
u
ance. Make sure that the accessory is pushed fully in.
Use
u
24 hours.
Place the appliance on the charging bracket whenever it is
u
not in use.
Warning! Before charging, be sure to empty all liquid contents
and dry thoroughly, to avoid damage to your appliance.
Charging the battery (Fig. C)
Make sure that the appliance is switched off. The battery
u
will not be charged with the on/off switch in the on posi-
tion.
Place the appliance on the charging bracket (5).
u
Plug in the charger. Switch on at the mains.
u
Leave the appliance to charge for at least 21 hours.
u
(Original instructions)
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance can
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C.
To switch the appliance on, slide the on/off switch (1)
u
forward to position 1.
To switch the appliance off, slide the on/off switch (1) back
u
to position 0.
Wet and dry pick up
For everyday spills of dry material, use your appliance
u
without the squeegee accessory.
Warning! Your product is designed for light spills only.
This appliance can also be used to pick up everyday liquid
u
spills. Use the squeegee accessory on non-absorbent,
hard surfaces. On absorbent surfaces, such as carpet,
your appliance will pick up wet spills better without the
accessory.
For best performance on hard surface wet pickups, insert
u
squeegee into the bowl nozzle opening.
For best results when using this accessory, hold the appli-
u
ance at an angle of 45° and pull it slowly towards you.
u
there is any liquid in the bowl, do not turn the unit upside
down, sideways, point the nozzle upward, or shake the
vac excessively.
After picking up liquid substances clean the appliance and
u
not properly cleaned after wet pickups.
Before charging, be sure to empty all liquid contents and
u
dry thoroughly, to avoid damage to your appliance.
Optimising the suction force
cleared regularly during use.
Emptying and cleaning the product.
Warning!
regularly.
Press the bowl release button (2) and pull the dust bowl
u
(3) straight off.
While holding the dust bowl over a bin or sink, pull out the
u
To replace the dust bowl, place it back onto the handle
u
Warning!
ENGLISH
-
7