How To Fill Water; Using The Garment Steamer - Panasonic NI-GWE080 Operating Instructions Manual

How to fill water

The plug must be removed from the socket outlet
before the water tank is filled with water.
1. Remove the water tank by gently lifting its tail upward
from the middle of the power base. Invert the water
tank upside down, and hold it bottom up.
2. Open the cap on the bottom of the water tank.
1
Put the water tank under a faucet and fill it with proper
2
amount of water.
Close the cap correctly.
3
2
1
3
3. Attach firmly the water tank back to the power base.
Notes:
ａ） The capacity of the water tank is about 2 L when water
reaches the lower part of the water inlet. Please fill the
water tank with a proper amount of water as needed.
b) Please fill the water tank with tap water. In case you live in
an area with hard water, scales build-up quickly may occur
so we recommend using distilled water or purified water.
c) When filling water, accumulating water may occur in the
groove around the water inlet and the water tank which is
not a malfunction. Please clean any water in the groove
before installing the water tank back.
10

Using the garment steamer

1. Hang the garment on the hanger.
Insert the power plug into the household outlet.
2. Set the power button to " " or " " position to light the
power indicator up.
Level Brightness Start steaming
Approx. 80
seconds
Approx. 50
seconds
3. set the steam selector according to the required " " / "
steam.
Please hold the steamer head by the shaded area.
Shaded area represents the hand-held area.
4. Steaming the clothes.
We recommend to put the steam head into the steamer
holder when you sort out or change your clothes.
5. Set the power button to " 0 " when you
have finished using, unplug the power
plug.
Notes:
"
a) When the hose slacken, the steam will be clogs partially
with noise from hose.
b) If the amount of water in the water tank less than
" " line, please add water.
c) Do not remove the water tank and hose from the base
during use.
d) To close steam, turn off the power button.
e) There may be water dripping from nozzle on the
clothes, this is not a malfunction.
f ) Turn off the power button, unplug the power plug
when you take out the water tank from the power base.
g) The power indicator light will be repeatedly lit and
extinguished when the water in the water tank
decreases, it is normal.
Fabric and ironing recommendations
Power Steam
Recommendations
Fabric
button selector
To iron normal
ACRYLIC, ACETATE
wrinkles from thin
NYLON, SILK clothing
POLYESTER, RAYON
To iron stubborn
wrinkles from thin
CHIFFON
clothing
To iron normal
wrinkles from
WOOL thick clothing
COTTON, LINEN To iron stubborn
wrinkles from
thick clothing
Note:
Do not use the appliance with leather fabric.
Test on an inconspicuous area when using with expensive
products, special materials, fibers weak against heat.
(Velvet, wool, cashmere, acrylic, silk, etc.)
11